Got a Freestyle Buggy at last!

Phaeton

Moderator
Staff member
This was how I did Bumble, I'm not sure your steel is strong enough, but I'm not engineer & I do tend to over rather than under engineer

 

250buggys

Active member
This was how I did Bumble, I'm not sure your steel is strong enough, but I'm not engineer & I do tend to over rather than under engineer

Thanks, I used 3mm. I'll keep an eye out for some thicker gauge channel and go again. At least for now the steel should be stronger than the welds.

Did you put softer springs to put on the front?
 

250buggys

Active member
This was how I did Bumble, I'm not sure your steel is strong enough, but I'm not engineer & I do tend to over rather than under engineer

Ordered some thicker gauge steel for the suspension mount. Should be much stronger.

Screenshot_20220518-151119752.jpg
 

Attachments

  • Screenshot_20220518-151119752.jpg
    Screenshot_20220518-151119752.jpg
    440.7 KB · Views: 0

Phaeton

Moderator
Staff member
If you ask @Danny nicely he'll send you a file of a profile that you can put on the side of the channel to grind down to.
 
Top