CV Cover?

[wagon]

Anybody have any nifty ideas to cover up the ends of these?

Guess it's not 100% necessary but may be a little tidier. 

 

[Buggybloke]

mine are empty altogether, ... not sure what's been done to them...... all I have are the ends of the shaft wilth a big hexagon shaped hole, with the cut-outs fole the CV ballbearings.....I'll take a pic and post it....

 

[wagon]

Oh - of course I handn't thought of that....

All that bearings gubbins could come out no bother couldn't it, actually if I was really keen I could weld a plate over or something.....

Would look a bit like a cake mould left open!  ;D

 

[herman]

Get your fingers onto the ball carrier and spin it 90 degrees so it stands up.
Then wiggle and pull. It does come out, but usually is stuck due to groves from the balls.
Have fun.

 

[Steve]

I used a couple of electrical conduit box lids, that are the perfect size and cost about 20p each.
Sorry its a late post.

 

[RichardG]

I welded a bit of steel onto mine to cover up the hole. ;D

 

[wagon]

Thanks for the relplys - Haven't actually done anything yet!  :-[

 

[CAW]

Hi,

I was thinking the same the other day, tried a plastic bottle base but too big, then tried a Rappor coffee jar lid  ;D, the 200g and 300g lid are the same size,  .. It's a push fit but a bit of sealant would make it watertight, you could always trim it down to.

And  there free after you've drank the coffee

Andy