MGF Wheel Adapters

Phaeton

Moderator
Staff member
I used this company I think, http://www.ebay.co.uk/itm/PCD-Adapt...heels_tyre_Trims_Trims_ET&hash=item4624bac64c just tell them what you want & they will drill to your specification.

Problem you will have if you don't use MGF wheels is that you will have to space out the rears by 25mm each (50mm total), which will mean it's even wider at the back, it's already going to be 50mm+ already, which you can get back by just spacing out the front.

You could just take off the rear hubs & get them re-drilled at Mini PCD, no idea if this is possible as I went the other way.

Alan...
 

Danny

Administrator
Which way did you go Alan?

I dont want to use my existing wheels just dont want to use MGF wheels :)
 

Phaeton

Moderator
Staff member
I went with putting 25mm spacers on the front hubs & converted the Mini PCD to the MGF PCD & run MGF rims. That makes the track the closest, the front is still very slightly narrower than the back (10mm each side I think) but not too obvious. If you don't want to use MGF rims, then logically only option is to take the hubs off, take them to an engineering shop & see if they can re-drill at whatever PCD you're after.

Alan...
 

Phaeton

Moderator
Staff member
Spot on them, not a bad price either apart from the postage UK based as well which will make it easier if they come out wrong
 

Phaeton

Moderator
Staff member
PCD of the hubs are Classic Mini 4x 4" with 3/8" UNF studs
The wheels are MGF 4x 95.25mm with 12mm studs
Finished width 25mm each adaptor
There is no spigot bore on the inside as the Mini doesn't have one
Spigot for MGF wheel is 56mm

That is the spec of mine, assuming you are putting them on the front
 

Danny

Administrator
I need to fill this form in :-\


Hub details
Adapter thickness 30mm
PCD 4"
Centre bore
Centre bore inner nose length
Stud hole size
Stud hole drilling Flat / 60 degrees

Wheel details
PCD 4x 95.25mm
Centre bore 56.6cm
Outer nose length
Stud size
Treaded / Studs
 

Phaeton

Moderator
Staff member
Danny":wigtx4dw said:
I need to fill this form in :-\


Hub details
Adapter thickness 30mm YES
PCD 4" YES
Centre bore You need to measure the diameter in the middle of the Mini hub for clearance
Centre bore inner nose length Probably 6-10mm
Stud hole size 10mm (clearance for 3/8th)
Stud hole drilling Flat / 60 degrees 60 Degrees

Wheel details
PCD 4x 95.25mm
Centre bore 56.6cm
Outer nose length 6-10mm
Stud size 12x1.25
Treaded / Studs Your choice, do you want to you wheel nuts or studs
 
Top