Brake fittings - sizes

A

Angel Boy

New member
The buggy has the original pipes siezed into the brake and clutch master cylinders and I've had to "twist" the brake pipe to get it off the rear t-piece it was connected to.  I'm looking to replace the whole lot with possibly braided line as I might have a source who can supply it to me.  Can anyone confirm the sizes of the bits which screw into all the relevant places?  They all look the same size, but would appreciate some knowledgable person to confirm.

Thanks,
Andy
 
Phaeton

Phaeton

Moderator
Staff member
Sorry Andy did see this before & forgot to answer. They're 3/8" UNF assuming they are standard Mini, there's only one that might be different depending on your master cylinder which might be a 10mm thread, same pipe but bigger thread. It was so they went back correctly onto the bias valve.

Alan...
 
You must log in or register to reply here.
Top