Managed to get a bit done today started with finishing the water pipes with clips, apart from the overflow tank that is done, but want to see how much space is left before committing to using the MX5 one, may need a smaller one
Next had a look at the air intake made up a pipe to take the crank breather, for now the air filter is going behind the radiator, need to make up a bracket to mount the MAF, there is also what looks like a air temp sensor, need to find if that can be mounted after the MAF
Clamps had come for the fuel lines so all that was finished off including the rollover vent, then after fitting the viton sheet under the brackets, fitted a couple of Rivnuts for the bodywork when I get that far.
Then fitted new handbrake cables, just need a couple of the spring clamps to hold the cables in place
Finally laid out the wiring, there's a hell of a lot more than I remembered & I'm missing set of 3 relays, I saw them last week, just a tip, don't get old!
Next had a look at the air intake made up a pipe to take the crank breather, for now the air filter is going behind the radiator, need to make up a bracket to mount the MAF, there is also what looks like a air temp sensor, need to find if that can be mounted after the MAF
Clamps had come for the fuel lines so all that was finished off including the rollover vent, then after fitting the viton sheet under the brackets, fitted a couple of Rivnuts for the bodywork when I get that far.
Then fitted new handbrake cables, just need a couple of the spring clamps to hold the cables in place
Finally laid out the wiring, there's a hell of a lot more than I remembered & I'm missing set of 3 relays, I saw them last week, just a tip, don't get old!