Hi people
Iv just joined the forum/ group.
Iv very little experience of any kind in this type of thing. So il apologise in advance if I come across as a nagger ect.
Basically iv acquired a semi half finished project,
a road Registered quadzilla rl300.
It's been stripped down to bare frame for a repaint, built back up with original engine ect, Few new parts here and there pretty much 90% good to go.
So basically I'm trying to do as much as I can myself. It had been sat for over 12 months when i got it,
Eventualy I managed to get it starting up and running ok (so so) by myself.
But that was Last summer,
No, i'm having no joy even getting it fired up.
I've removed the carburetor to give it a good clean ect, And I realised it isn't actually original one, The float pis was knackered so First port of call is trying to identify what carburetor should I be trying to source.
Any advice is much appreciated.
Thanks in advance
Iv just joined the forum/ group.
Iv very little experience of any kind in this type of thing. So il apologise in advance if I come across as a nagger ect.
Basically iv acquired a semi half finished project,
a road Registered quadzilla rl300.
It's been stripped down to bare frame for a repaint, built back up with original engine ect, Few new parts here and there pretty much 90% good to go.
So basically I'm trying to do as much as I can myself. It had been sat for over 12 months when i got it,
Eventualy I managed to get it starting up and running ok (so so) by myself.
But that was Last summer,
No, i'm having no joy even getting it fired up.
I've removed the carburetor to give it a good clean ect, And I realised it isn't actually original one, The float pis was knackered so First port of call is trying to identify what carburetor should I be trying to source.
Any advice is much appreciated.
Thanks in advance