Top Engine mount bolts

[Danny]

Hello,

When I sold my old engine, I left the bloody engine mount bolts in. The ones that go to just below the head.

Anybody have a couple of these?

Cheers

Danny

 

[esdebe]

He is talking about the engine stabiliser on the Clutch housing side on the engine.

He needs the long and short bolt.

Simon

 

[Danny]

cheers simon


lol

Danny

 

[funbuggydave]

Any suitable length 5/16"UNF bolts should do the trick, make sure the long one isn't too long as when you tighten it up it bottoms out when you think you're trying to squeeze the bush tight and the bloody thing shears in the block so tight you can't get it out with a stud extractor.........
Not that I'm speaking from experience :roll:
Dave

 

[esdebe]

I had a spare one, until I sheared mine when tightening it up, and then had to drill it out and re-tap....

Simon

 

[Danny]

could someone measure the lengths for me so I can order them up??

Cheers

Danny

 

[esdebe]

The Long one
http://www.minispares.com/Product.aspx?pid=33377
The short one
5/16" x 1 7/8" UNF

Also check this out for the original part numbers
http://www.heritagegarage.com/catalog/engine/45.htm