mines got a bonnet
New member
have just tried to fit exhaust as the build manwell instructs. i have cut the LCB monifold down to just above the bend and also cut a small section off the Y piece to improve ground clearance. the problem i have is that the Y piece seem to be very close to the RHS drive shaft pot, it is not touching but i measure the clearance as only 2mm. has anyone else got the exhaust as close? does anyone think i will get problems or damage from the radient heat?
when making brackets to hold the back box, is it ok to just mount then solidly to the subframe or should i use rubber bobbins like on a minbin?
so many questions, for this i am sorry
when making brackets to hold the back box, is it ok to just mount then solidly to the subframe or should i use rubber bobbins like on a minbin?
so many questions, for this i am sorry