ChaosMS
Active member
Hi everyone, New to forum so just thought I would post a few pics of my buggy project here in the UK, still got a bit to do but the project is going well so far, without too many major issues (those will come when I try to get it registered for road use). The buggy has been designed by myself (and a good bit of CAD software) and is powered by a suzuki swift engine and box.
Anyway I have a LOT of build pics over on my build site but here are a few to get you started :-
Day 1 280 feet of 1.25" (32mm if your in the UK) 2mm wall ERW tube - it dosent look much once its chopped up!
Majority of chassis parts bent to correct angle with the homemade tube bender:-
Start of the lower chassis section:-
Chassis main roll over bar and rear cage:-
Chassis midsection and upper roll cage:-
Chassis Upper section in place - starting to look right :-
chassis with diagonals and engine mounts in place (and a bit of undercoat):-
Anyway I have a LOT of build pics over on my build site but here are a few to get you started :-
Day 1 280 feet of 1.25" (32mm if your in the UK) 2mm wall ERW tube - it dosent look much once its chopped up!
Majority of chassis parts bent to correct angle with the homemade tube bender:-
Start of the lower chassis section:-
Chassis main roll over bar and rear cage:-
Chassis midsection and upper roll cage:-
Chassis Upper section in place - starting to look right :-
chassis with diagonals and engine mounts in place (and a bit of undercoat):-