If I remember correctly although that is no longer a given, you've had that slow puncture for about 3 years now, GO GET IT FIXED!!!!!! or buy new tyres.Other than a flat tyre I am good to go![]()
250buggys":2khgkzo1 said:Danny, it's funny how you always have a drama before Stoneleigh.
At least the HG is done, did you get some miles on the buggy so you have piece of mind for the journey there?
I remember when my 220 coupe turbo blew the HG, it's always in the back of your mind whether it will go again.
Lol the only damage from the the roundabout tour is 2 rimmed alloys on the inside edgesPhaeton":2660ojqo said:If this was from your over the roundabout excursion how come you didn't notice before or have you had another trip that you haven't told us about?
They were not bent when I changed the shocks...Phaeton":1vgxlutb said:I reckon that is when you bent those but you changed the shocks afterwards
My thoughts for what they are worth is it will be horrible to drive, lots of 'fast road' clutches are very off/on/sharp take up, bearing in mind your buggy weighs only 50% of a MGF then any form of smooth getaway might prove difficult. If the bite point was low I would have thought it would be a worn plate, but you're complaining of a high bite, which could suggest maybe a pedal throw issue.Danny":27daqnhn said:This is the clutch I am going for http://www.ebay.co.uk/itm/ROVER-MGF-1-8 ... Ciid%253A1
and also fitting a new slave cylinder and arm![]()
Hmmmmmm I seeePhaeton":15k4k6th said:My thoughts for what they are worth is it will be horrible to drive, lots of 'fast road' clutches are very off/on/sharp take up, bearing in mind your buggy weighs only 50% of a MGF then any form of smooth getaway might prove difficult. If the bite point was low I would have thought it would be a worn plate, but you're complaining of a high bite, which could suggest maybe a pedal throw issue.Danny":15k4k6th said:This is the clutch I am going for http://www.ebay.co.uk/itm/ROVER-MGF-1-8 ... Ciid%253A1
and also fitting a new slave cylinder and arm![]()
Danny":h5jlqrlw said:So anybody got any suggestions on electrical connectors that will take some big cables and little ones as well![]()
Phaeton":1vvf7nl7 said:Danny":1vvf7nl7 said:So anybody got any suggestions on electrical connectors that will take some big cables and little ones as well![]()
What big cables? there aren't any big cables going forward all the big stuff stays within the subframe. Unless that dodgy electrician you used has put a huge cable to the fusebox
Brolac's there's no big cables thereDanny":17r78z23 said:lighting![]()